Fluke Networks PRO3000F60 Analog Probe with 60Hz Filter

Fluke Networks® PRO3000F60 Analog Probe with 60Hz Filter

Innovative filtered probe obstructs signal of 60 Hz external interference

Switch between filtered and unfiltered modes with one button press

Tone and trace wire on non-active networks

Auto-off capability extends battery life

Loud probe speaker is audible in noisy locations

Signal Interference can be caused by multiple sources (I.e. power cables, fans, lighting, etc.) and can make tracing communication cabling almost impossible.

The Pro3000F probe utilizes innovative filter technology to obstruct signal interference to make tracing your cable easier, regardless of the work environment. Depending on the region, signal interference may be at 60 Hz, which is most common in North America, or 50 Hz, which is more common in Europe and Asia. For this reason, there are 2 versions of the Pro3000F Filtered Probe. The Pro3000F60, which obstructs 60 Hz signals and its harmonics and the Pro3000F50, which blocks interference at 50 Hz and its harmonics.

Technicians can also switch between filtered and unfiltered modes with a simple push of a button. The probe’s loud speaker also allows for use in noisy locations and for tracing cable through drywall, wood and other enclosures. The probe also touts an auto-off feature that deactivates the probe after 5 minutes to conserve battery life.

The Pro3000F Filtered probe becomes even more useful when paired with the Pro3000 Tone Generator. The Pro3000 Tone Generator allows for direct connection to unterminated wire using the angle bed of nails clips or terminated RJ-type jacks with the male RJ-11 plug. The tone generators strong tone and SmartTone technology allows for precise pair identification up to 10 miles (16 km) away.

Feature Pro3000 Analog

Tone and Probe Pro3000F60-KIT Intellitone Pro 200

(MT-8200-60-KIT)

Analog Signal tracing x x x

Digital Signal tracing x

SmartTone x x x

Used on Inactive Networks x x x

Used on Active Networks x

Frequency Filter 60 Hz

3.5 mm Jack x x

Replacable Tip x x

Auto-Off X (Probe – 5 minutes) X (Toner = 2.5 hours, Probe = 1 hour)

Wiremap x

Signal Strength Indicator x

Pro 3000 Intellitone Pro MicroMapper TS100 PRO MS2-100 CIQ-100

Port Location ID

Digital Toning ✔ ✔ ✔

Analog Toning ✔ ✔ ✔ ✔ ✔ ✔

Switch Presence ✔ ✔ ✔

VDV Service Detection ✔ ✔

Cable Verification

Cable Wiremap ✔ ✔ Graphical Graphical

Cable Length ✔ ✔ ✔

Qualified Cabling Speed (10/100/1000/VoIP) ✔

Cable Troubleshooting

Indentify open/short ✔ ✔ ✔ ✔ ✔ ✔

Distance to open/short ✔ ✔ ✔

Locate crosstalk fault ✔

Identify and locate impedance fault ✔